- TR Products»
- Brass Inserts for Plastic»TR Plastic ProductsSpacers & PillarsScrewsSets, Bolts & StuddingSocket ProductsNutsWashersSheet Metal FastenersTR Self Locking NutsScrews for PlasticsBlind Rivet NutsBlind RivetsTR Security FastenersMicro-Diameter Fasteners from M0.6Bonded Seals, O-Rings & CirclipsFasteners to Japanese StandardsSpring Steel FastenersManufacturing ConsumablesSpecial ManufactureProduct Literature
Broaching-sert - Unheaded
Other materials available to order
For use in:
Note: Due to the fact that fastening applications differ greatly, the below information is for guidance only and is correct to the best of our knowledge. The customer must satisfy themselves with the performance of the fastener and validity of the data. TR Fastenings will not be held responsible for any failure that may occur from the use of this information.
|Thread size||L mm||K mm||N mm||B mm||C mm||Recommended Hole Size mm (-0.0/+0.1)||Minimum Wall Thickness mm|
* Non-preferred – please enquire for availability
Broaching-Sert Information for designers
The Broaching-Sert is a press-in insert, designed for post mould installation into thermosets. The sharp knurls of the insert cut into the mating material during installation thereby reducing stress in brittle thermosets.
Simple, press-in installation
Allows for thin walls in the boss
Good pull out and torque resistance
The Broaching-Sert should be installed with a press that can provide a steady squeezing action to prevent damage to the mating boss The insert should be allowed to freely rotate during installation
Please make a selection from the criteria above