- TR Products»
- Brass Inserts for Plastic»TR Plastic ProductsSpacers & PillarsScrewsSets, Bolts & StuddingSocket ProductsNutsWashersSheet Metal FastenersTR Self Locking NutsScrews for PlasticsBlind Rivet NutsBlind RivetsTR Security FastenersMicro-Diameter Fasteners from M0.6Bonded Seals, O-Rings & CirclipsFasteners to Japanese StandardsSpring Steel FastenersManufacturing ConsumablesSpecial ManufactureProduct Literature
Fin-Sert - Headed
Other materials available to order
For use in:
Note: Due to the fact that fastening applications differ greatly, the below information is for guidance only and is correct to the best of our knowledge. The customer must satisfy themselves with the performance of the fastener and validity of the data. TR Fastenings will not be held responsible for any failure that may occur from the use of this information.
|Thread size||L mm||B mm||C mm||N mm||K mm||Recommended Hole Size Mm (-0.0/+0.1)||Minimum Wall Thickness mm|
* Non-preferred – please enquire for availability
Fin-Sert Information for designers
The Fin-Sert is a press-in insert, designed for post mould installation into thermoplastics. The combination of fins and knurls provides good levels of pull out and torque resistance.
Simple, press-in installation
Free running female thread
Good pull out and torque resistance
The Fin-Sert should be installed with a press that can provide a steady squeezing action to prevent damage to the mating boss.