- TR Products»
- Brass Inserts for Plastic»TR Plastic ProductsSpacers & PillarsScrewsSets, Bolts & StuddingSocket ProductsNutsWashersSheet Metal FastenersTR Self Locking NutsScrews for PlasticsBlind Rivet NutsBlind RivetsTR Security FastenersMicro-Diameter Fasteners from M0.6Bonded Seals, O-Rings & CirclipsFasteners to Japanese StandardsSpring Steel FastenersManufacturing ConsumablesSpecial ManufactureProduct Literature
Flow-Sert - Unheaded
Other materials available to order
For use in:
Note: Due to the fact that fastening applications differ greatly, the below information is for guidance only and is correct to the best of our knowledge. The customer must satisfy themselves with the performance of the fastener and validity of the data. TR Fastenings will not be held responsible for any failure that may occur from the use of this information.
|Thread size||L mm||K mm||A min. mm||C mm|
* Non-preferred – please enquire for availability
Flow-Sert Information for designers
The Flow-Sert is a blind insert, designed to be installed during the moulding process.
The blind end prevents plastic ingress during moulding
Very high pull out and torque resistance
The Flow-Sert is designed to be installed during moulding. It is critical that the mould pin used is designed to locate the Flow-Sert and prevent plastic ingress.
Please contact your nearest TR location for mould pin design assistance.
Please make a selection from the criteria above