- TR Products»
- Brass Inserts for Plastic»TR Plastic ProductsSpacers & PillarsScrewsSets, Bolts & StuddingSocket ProductsNutsWashersSheet Metal FastenersTR Self Locking NutsScrews for PlasticsBlind Rivet NutsBlind RivetsTR Security FastenersMicro-Diameter Fasteners from M0.6Bonded Seals, O-Rings & CirclipsFasteners to Japanese StandardsSpring Steel FastenersManufacturing ConsumablesSpecial ManufactureProduct Literature
Heat-Sert - Headed
Other materials available to order
For use in:
Note: Due to the fact that fastening applications differ greatly, the below information is for guidance only and is correct to the best of our knowledge. The customer must satisfy themselves with the performance of the fastener and validity of the data. TR Fastenings will not be held responsible for any failure that may occur from the use of this information.
|Thread size||L mm||B mm||C mm||N mm||K mm||Recommended Hole Size mm (-0.0/+0.1)||Minimum Wall Thickness mm|
* Non-preferred – please enquire for availability
Heat-Sert Information for designers
The Heat-Sert has been designed for post mould installation into notch-sensitive thermoplastics using heat. The rounded knurls alleviate stress in the mating boss.
Designed specifically for notch-sensitive plastics
Symmetrical design for automated installation
High pull out and torque resistance
The Heat-Sert is installed using heat and you must ensure that the insert softens, but does not melt the plastic which helps avoid flash forming around the top of the insert.