- TR Products»
- Brass Inserts for Plastic»TR Plastic ProductsSpacers & PillarsScrewsSets, Bolts & StuddingSocket ProductsNutsWashersSheet Metal FastenersTR Self Locking NutsScrews for PlasticsBlind Rivet NutsBlind RivetsTR Security FastenersMicro-Diameter Fasteners from M0.6Bonded Seals, O-Rings & CirclipsFasteners to Japanese StandardsSpring Steel FastenersManufacturing ConsumablesSpecial ManufactureProduct Literature
Sonic-Sert - Headed
Other materials available to order
For use in:
Note: Due to the fact that fastening applications differ greatly, the below information is for guidance only and is correct to the best of our knowledge. The customer must satisfy themselves with the performance of the fastener and validity of the data. TR Fastenings will not be held responsible for any failure that may occur from the use of this information.
|Thread size||L mm||B mm||C mm||N mm||K mm||Recommended Hole Size mm (-0.0/+0.1)||Minimum Wall Thickness mm|
* Non-preferred – please enquire for availability
Sonic-Sert Information for designers
The Sonic-Sert has been designed for post mould installation into thermoplastics using heat or ultrasonics with the opposing knurls providing a combination of high pull out and torque resistance.
Allows for thin walls in the boss
High pull out and torque resistance
The Sonic-Sert is installed using either heat or ultrasonics.
Where heat is used you must ensure that the insert softens, but does not melt the plastic, which helps avoid flash forming around the top of the insert.
Ultrasonic installation works best with low amplitude vibrations and enough power to soften the surrounding plastic.
Care should be taken to avoid excessive downward pressure being applied during installation which can result in the insert being forced into the hole rather than allowing the plastic to soften around it.
Please make a selection from the criteria above